The FCC requires the following statement for yourinformation: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance withthe manufacturer's instructions, may cause interference to radio and television reception. The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User Manual.Unauthorized changes or modifications could void the user's authority to operate the equipment.ĬLASS B DIGITAL DEVICE STATEMENTThis equipment has been tested to FCC requirements and has been found acceptable for use. Test the status by arming and disarming the system in bothAWAY and STAY Modes.įEDERAL COMMUNICATIONS COMMISSION STATEMENT: The LED stops flashingORANGE and then shows the status of the control panel (seeLED indications).Ĥ. IMMEDIATELY press (one second) and release the Programbutton again. Press (one second) and release the Program button the LED willstart flashing GREEN.Ģ. Ensure the House ID is enabled in thepanel programming.ġ. NOTE: The System Control Panel must be capable of transmittingsystem status, for example, an LYNX Touch, LYNX Plus, or a VISTAPanel with a 5883 transceiver. TO USE FOR SYSTEM STATUS ENROLL RF HOUSE IDCODE INTO MODULE
Press and continue to hold the Program button theLED turns RED, then turns off, then RED again release the Program button. Test by pressing each Wireless Key buttonenrolled in the relay module the relay moduleshould click for each Wireless Key button press. Repeat the process for each Wireless Key button up to 7 buttons total.Ĥ. Press the Wireless Key button to enroll it and the Press (one second) and release the Programbutton the LED will start flashing GREEN.Ģ. TO USE WITH 5800 SERIES WIRELESS KEYS(Standard mode only), ENROLL WIRELESS KEYSINTO MODULEġ. Honeywell 5877 Installation Manual and Setup Guide
NOTE: Mountingscrews mustbeused ininstallationswheretemperaturesdrop to freezing32 F (0 C). Optional screws (supplied) are recommended. Use the double-sided tape (supplied) to mount the module. The 5877 wireless relay module allows control of non-security system devices from compatible 5800 series wireless keys.The module also includes an LED that can provide panel system status information. Honeywell 5877 Installation Manual and Setup Guideĥ877 Relay Receiver - Installation Instructions
0 kommentar(er)
